KB – HID Firmware Installation, major steps

HID Firmware, Knowledge Base

Flashing HID Firmware.

HID FIRMWARE FLASH INSTRUCTIONS FOR EDGE AND EDGE EVO CONTROLLERS

  1. place the .img file in the C drive
  2. FTP into device with user: root and password: pass
  3. run the following command: put c:\E400_300.img flash_all_force [OR] ftp: put C:\ <file name> flash_all_force
  4. watch screen to completion of flash (typically 4 to 5 minutes)
  5. Set up network settings of controller; all network settings will be the same except for the host IP address and the Here I Am interval which should be set to 120 seconds for HID EDGE EVO or VertX EVO.
  6. You might have to do a power reset before point 5.

Investor Relations

Middleware Associates, LLC. is a privately held corporation that was founded by Patrick Conners in January, 2004. For information reqarding a potential merger, acquisition or an investment in our future technology please Contact Us

Best Selling Products

CredoID Version 4.x is the latest open systems Access Control Platform that integrates to any environment via a free API Interface. The best selling single door controller is without question the HID Mercury LP1501 PoE+ Controller